Resolving Hard Drive Hardware Problems

Hardware problems occur at two different times in the hard disk's life cycle. You will often see the hard disk after an error at first to add a new drive. Problems in this phase are usually caused by improper cabling or jumper odabira.Prva thing to do is to review your installation steps and check that the connection is properly seated, master and slave drives are bridged by the cable properly and that your disk geometry correct in the BIOS .

, however, is another common cause of hardware errors on the new plant is sometimes different brands of hard drives do not play nicely together in a master / slave relationship. Try keeping the drives from different manufacturers on a separate hard disk controllers. Some techs believe that it is useful to keep all the hard drives in any system of the same brand. I've had good experiences mixing different brands in my system, but I'm not a brand slave drive the master drive different brands.

for the second time the hardware errors are displayed when there is a component that is failing. A typical hardware problems for hard drives have symptoms such as:

• dead drive (I can not even hear the spin)
  
• common error in reading and / or writes
  
• "No fixed disk present" error
  
• Numerical errors 1701, 1780, 1781, 1790 or 1791 to start
  
• "Hard Disk Controller Failure" message

Some of the same rules as with the new drive. First, remove the case and check whether the data (ribbon) cable is properly seated on both hard disk connection to the motherboard connection. Then check the power cord. If all cables are properly seated, try to replace with a new ribbon cable.

Some of the same rules as with the new drive. First, remove the case and check whether the data (ribbon) cable is properly seated on both hard disk connection to the motherboard connection. Then check the power cord. If all cables are properly seated, try to replace with a new ribbon cable.

Some of the same rules as with the new drive. First, remove the case and check whether the data (ribbon) cable is properly seated on both hard disk connection to the motherboard connection. Then check the power cord. If all cables are properly seated, try to replace with a new ribbon cable.

If the drive does not seem to be getting power, try replacing the power cord. If the drive is connected using a Y power cable, try using a straight through cable instead.

1. Back up regularly
   
2. Run maintenance utilities on a regular basis